FAQ

Should I retest after renovating or finishing my basement?

Direct answer

Yes. Slab cuts, new sumps, waterproofing, HVAC replacement, air-sealing, and basement finishes all change how soil gas enters or accumulates. Retest once the work is done and the house is back to normal operation.

More detail

Renovations rewrite the pressure map a radon number depends on. A bathroom rough-in cuts the slab. Interior drain tile and a new sump connect the basement to the perimeter soil. Spray foam and new windows tighten the envelope, which strengthens the stack effect that pulls on the soil. A furnace swap changes basement airflow. Finishing the basement does something subtler and more important: it moves bedrooms and sofas onto the lowest level, converting a number nobody breathed much of into one somebody sleeps in. The retest rules are the ordinary ones, closed-house conditions, lowest lived-in level, heating season if the calendar allows, and if a mitigation system exists it stays running for the test. Houses with systems deserve one extra check after any slab or foundation work: confirm the new penetration got sealed and the suction field still reaches it, which a gauge glance plus a retest covers. Timing-wise, let the dust settle and the house run normally for a week or two first. The basement finishing guide sequences this inside a project plan.

Authoritative sources

Ready to get started?

The inner Bluegrass sits on uranium-bearing limestone, and more than half of tested Fayette County homes have run elevated. Mon-Sat 8am-7pm.

Call (859) 780-8148Text us

Prefer to text? Open your texting app